Users Manual Part 1

39
Nerve Integrity Monitor
1
2
3
4
5
6
7
8
9
10
11
12
13
1 Nervassure Waveform. Appears
as a Blue Trace on all channels if
Show Nervassure Waveforms is on
(default) in the Settings Nervassure
panel.
2 EMG Waveform. Appears as a white
trace on all channels.
3 Nervassure Latency value.
4 Nervassure stimulation level.
5 Values. The system displays the
EMG measured values in white with
the largest value boxed in yellow.
The system displays the Nervassure
values in blue.
6 Alarm Mute button. This button
shows that an alarm condition is
present.
7 Limit Lines. The system displays the
upper limit for latency and lower
limit for amplitude as red dotted
lines and the loss of signal (LOS) as
a solid line.
8 Baselines. The system displays the
latency and amplitude baseline as
solid lines with hash marks.
9 Trend lines. The system displays
latency and amplitude as a series of
points based on the trend color.
10 Alert. The system shows the alarm
(if sounded) mute buttons for
amplitude and latency separately
and colors the bottom bar
according to the combined alarm
level.
11 Nervassure ON selection button.
Use this check box to pause/
continue Nervassure stimulation
once the session has started.
12 Time Base.
13 Session duration.
FCC use only, not for Medical use