User's Manual

IC: 3147A-BL654
This device contains licence-exempt transmitter(s)/receiver(s) that comply with ISED Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions:
1. This device may cause interference; and
2. This device must accept any interference, including interference that may cause undesired operation of
the device.
Cet appareil contient des émetteurs / récepteurs exempts de licence qui sont conformes au (x) RSS(s)
exemptés de licence d’ISED Canada. L’opération est soumise aux deux conditions suivantes:
1. Cet appareil ne doit pas causer d’interférences
2. Cet appareil doit accepter toute interférence, y compris les interférences pouvant provoquer un
fonctionnement indésirable de l’appareil.
This radio transmitter (IC: 3147A-BL654) has been approved by ISED Canada to operate with the antenna
types listed below with the maximum permissible gain indicated. Antenna types not included in this list, having
a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
Le présent émetteur radio (IC: 3147A-BL654) a été approuvé par ISED Canada pour fonctionner avec les
types d’antenne énumérés ci-dessous et ayant un gain admissible maximal. Let types d’antenne non inclus
dans cette liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour
l’exploitation de l’émetteur.
Manufacturer
Model
Type
Peak Gain (dBi)
2400 - 2500 MHz
Peak Gain (dBi)
2400 - 2480 MHz
Laird
NanoBlue
PCB Dipole
2
-
Laird
FlexPIFI
PCB Dipole
-
2
Laird
FlexNotch
PCB Dipole
-
2
Mag.Layers
EDA-8709-2G4C1-B27-CY
Dipole
2
-
Laird
mFlexPIFA
PIFA
-
2
Laird
Laird NFC
NFC
-
-
Laird
BL654-SA PCB printed
antenna
Printed PCB
0
Walsin
EDA-8709-2G4C1-B27-CY
Dipole
2
-
Radiation Exposure Statement:
The device has been found to be compliant to the requirements set forth in CFR 47 Sections 2.1091 and ISED
Canada RSS-102 for an uncontrolled environment. The antenna(s) used for this transmitter must be installed
to provide a separation distance of at least 12 mm from all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC ID: 2ATN7-ARG411M01
IC: 25152-ARG411M01
16 Ribocon Way, Progress Park, Luton, United Kingdom LU4 9UR ● P: [phone] ● www.argonelectronics.com