Instructions / Assembly

ManualsBrandsLakeland Mills ManualsHome DecorNorthern White Cedar Log Bridge

•

Read all instructions before starting.

Helpful Tips:

•

Do not completely tighten any screws until the unit

is fully assembled and setting on a level surface.

•

Use a rubber mallet (or a block of wood between the

hammer and the unit) to drive doweled ends into

holes as far as possible.

•

If you have hardware left over after completing your

unit, it most likely has been assembled incorrectly,

and may not be safe to use. Please call Customer

Service at 800-427-5136 for assistance.

•

Check all nuts and bolts for tightness before and

during each usage season.

NOTE: Cracks or Checks in logs are part of the natural

beauty of cedar logs and should not be considered defects.

Bridge Componants Hardware and Tools Required

(Not shown actual size)

Please check contents before assembly. If any items are missing or damaged, do not take the unit back to the

store. Call 1-800-427-5136 for customer service, we will save you time by correcting any problems directly for you.

CF2960 Bridge

8 - Side Rails

2 - Middle

Posts

4 - End Posts

Bridge

12 - Washers

12 - 2” Hex Screws

16 - Screws

Rubber

Mallet

Block of Wood

& Hammer

7/16

Socket

Phillips

Screwdriver

NOTE:

Insert side rails into end post and one middle post as

shown in figure 1. Making sure the notches at the

bottom of the posts face the same direction, as shown

in figure 1. Repeat process to assemble the other

bridge side rail assembly.

STEP 1

Figure 1

Summary of content (2 pages)

PAGE 1
CF2960 Bridge Please check contents before assembly. If any items are missing or damaged, do not take the unit back to the store. Call 1-800-427-5136 for customer service, we will save you time by correcting any problems directly for you.
PAGE 2
STEP 2 Set the bridge on a smooth flat surface. Attach side rail assembly (with notches in post facing toward the bridge), with washers and hex head screws as shown in figure two. Repeat process with other side rail assembly. HEX HEAD SCREWS WASHERS Figure 2 STEP 3 Secure all dowel joints in place with screws perpendicular to the doweled end at the location indicated by the arrows in figure 3. Figure 3 Make sure the bridge is level, tighten all screws.