Instructions / Assembly

CF85 Country Garden Swing
Please check contents before assembly. If any items are missing or damaged, do not take the unit back
to the store. Call 1-800-427-5136 for customer service, we will save you time by correcting any problems
directly for you.
SWING COMPONENTS
2-Swing Bars
2 - 12” Arm
Supports
2 - Arms
2 - Back Uprights. (Left & Right )
2 - Seat Ends (Left & Right)
PORCH SWING HARDWARE
(Shown smaller than actual size)
6 - 1/4” x
5” Hex
Washer
Head
Screw*
* Hex Washer Head Screws may be sub-
stituted with Lag Screws and Washers.
* Hex Washer Head Screws may require:
 9/16” wrench
 7/16” socket or wrench
 3/8” socket or wrench
2 - Barrel Nuts 2 - 3/8” Washers
2 - 5” Eye Bolts
2- S Hooks
14 - 2 1/2”
Screws
TOOLS REQUIRED
Pencil & tape measure
7/16” Wrench or
socket
#2 Phillips Screwdriver
Rubber Mallet or Hammer
w/block of wood
Flat Head
Screwdriver
NOTE: Using a battery or electric power drill
with a socket attachment will make assembly
easier and faster.
NOTE: Read all instructions before starting.
NOTE: Cracks or Checks in logs are part of the natural
beauty of cedar logs and should not be considered defects.
Helpful Tips:
 To start lag screws, hammer into wood about 1/2” then use wrench or socket to
tighten.
 Use a rubber mallet (or block of wood between the hammer and the unit) to
drive doweled ends into holes as far as possible.
 If you have hardware left over after completing your unit, it most likely has
been assembled incorrectly, and may not be safe to use. Please call Customer
Service at 800-427-5136 for assistance.
 Check all nuts and bolts for tightness before and during each usage sea-
son.
Step 1 Assemble right and left, end swing assemblies. Insert the
12” arm support into the hole of the arm. Insert the doweled
end of the arm into the angled hole of the back upright. See
Figure 1. Repeat process for opposite side.
Figure 1
Left Right
Step 2 Install seat ends. The larger hole will attach to the 12” arm
support, and the angled hole will be toward the back. The
other two holes from the seat end will face the same direc-
tion as the two holes of the back upright. See Figure 2. Insert
5” lag screw through the predrilled holes on the back of the
uprights and into the doweled end of the arm. Repeat on
other end assembly.
Figure 2
Larger hole for arm support
Front
Angled hole for back upright
Pilot hole
5” Lag Screws
Seat end