Owner manual

ManualsBrandsLaMotte ManualsEquipmentOZONE - DPD LIQUID

OZONE - DPD LIQUID

1200 COLORIMETER, 0-3 ppm

CODE 3598

QUANTITY CONTENTS CODE

30 mL DPD #1A Free Chlorine Reagent P-6740-G

30 mL *DPD #1B Free Chlorine Reagent *P-6741-G

30 mL *DPD #3 Total Chlorine Reagent *P-6743-G

1 Colorimeter Tubes, with caps 0290-6

1 Water Sample Collecting Bottle 0688

1 1200 Colorimeter for Ozone DPD 26913

*WARNING: Reagents marked with an * are considered to be potential health hazards.

To view or print a Material Safety Data Sheet (MSDS) for these reagents go to

www.lamotte.com. To obtain a printed copy, contact LaMotte by e-mail, phone or fax.

NOTE: The primary use for this kit is in applications that use only ozone and no other

oxidizing disinfectants.

To order individual reagents or test kit components, use the speciﬁ ed code number.

INTRODUCTION

Ozone is sometimes used in place of, or in conjunction with, chlorine or other

halogens for disinfection of pool, spa or drinking waters. Recently, large aquatic

facilities have begun using ozone as a disinfectant in many artiﬁ cial habitats.

Summary of content (4 pages)

PAGE 1
OZONE - DPD LIQUID 1200 COLORIMETER, 0-3 ppm CODE 3598 QUANTITY 30 mL 30 mL 30 mL 1 1 1 CONTENTS DPD #1A Free Chlorine Reagent *DPD #1B Free Chlorine Reagent *DPD #3 Total Chlorine Reagent Colorimeter Tubes, with caps Water Sample Collecting Bottle 1200 Colorimeter for Ozone DPD CODE P-6740-G *P-6741-G *P-6743-G 0290-6 0688 26913 *WARNING: Reagents marked with an * are considered to be potential health hazards. To view or print a Material Safety Data Sheet (MSDS) for these reagents go to www.lamotte.
PAGE 2
OZONE TEST PROCEDURE - DPD METHOD Read the 1200 Colorimeter Manual before proceeding. Carefully wipe tubes dry before inserting into the colorimeter chamber. FREE AVAILABLE CHLORINE 1. Rinse and fill a colorimeter tube (0290) to the 10 mL line with sample water. Cap and wipe dry. 3. 1200 COLORIMETER •••••••••••••••••••••• ZERO READ Push the READ button to turn the meter on. Press the ZERO button and hold it for 2 seconds until bla is displayed. Release the button to take a zero reading (0.00 ppm).
PAGE 3
CAUTION: DO NOT leave reacted DPD samples in test tubes (0290). Discard sample and thoroughly rinse tubes. If allowed to remain, DPD will stain tubes, significantly impairing the operation of the 1200 Colorimeter. If necessary, acid wash, and vigorously clean glassware with test tube brush and detergent. DPD CHLORINE TEST METHOD SPECIFICATIONS APPLICATION Bottled water, aquatic waters, and non-chlorinated waters. RANGE 0 to 3.0 mg/L Ozone.
PAGE 4
LaMOTTE COMPANY Helping People Solve Analytical Challenges® PO Box 329 • Chestertown • Maryland • 21620 • USA 800-344-3100 • 410-778-3100 (Outside USA) • Fax 410-778-6394 Visit us on the web at www.lamotte.