Manual

n
SEQUENCES OF TESTS
SEQUENCE 1, SEQUENCE 2,andSEQUENCE 3 are alterable sequences. They may be edited using the EDIT function
mode. Any of the LaMotte pre-programmed tests or User Tests may be placed in these sequences in whatever testing
order that is preferred. Some examples of typical sequences are given below.
SEQUENCE 1 SEQUENCE 2 SEQUENCE 3
* 60 Molybdenum LR * 1 Aluminum * 3 Ammonia-N L F
79 Phosphate H 35 Cyanide 32 Copper DDC
9 Bromine LR 41 Fluoride 64 Nitrate-N LR
76 pH TB 53 Iron Phen 67 Nitrite-N LR
15 Chlorine 55 Manganese L 74 pH CPR
86 Silica HI 64 Nitrate N LR 78 Phosphate L
45 Hydrazine 26 COD Low 85 Silica Lo
32 Copper DDC 77 Phenols END OF LIST
51 Iron Bipyr 78 Phosphate L
END OF LIST 90 Sulfide LR
END OF LIST
NOTE: SequencesalwaysendwithEND OF LIST to indicate that there are no
more tests in the sequence.
These alterable sequences allow a series of tests to be setup that are run
frequently. The order of the individual tests in the sequence is determined by
the user. After running a test, press EXIT to escape back to the Sequence menu.
Move the t down to the next test listed and press ENTER/Q .Continuethis
pattern until the entire sequence has been completed.
ALL TESTS is a fixed sequence containing the LaMotte pre-programmed tests
and User Tests.
Modification of the alterable sequence is accomplished through the EDIT
function.ThisfunctionisexplainedindetailinthesectiontitledEDIT.
It should be noted that if a %T/ABS test is to be included in a sequence, the
%T/ABS test must first be setup as a User Test (but no actual calibration needs
to be performed, only select a name and wavelength).
Pressing the EXIT button while in a sequence menu will escape back to the
PROGRAMMED TESTS menu.
Pressing the OFF button at any time will turn the SMART Spectro off.
SMART SPECTRO SPECTROPHOTOMETER 05.04 27