Owner's manual

26 SMART Spectro Operator’s Manual 2.11

SEQUENCES OF TESTS

SEQUENCE 1, SEQUENCE 2, and SEQUENCE 3 are alterable sequences.

They may be edited using the EDIT function mode. Any of the LaMotte pre-

programmed tests or User Tests may be placed in these sequences in whatever

testing order that is preferred. Some examples of typical sequences are given

below.

SEQUENCE 1 SEQUENCE 2 SEQUENCE 3

* 60 Molybdenum LR * 1 Aluminum * 3 Ammonia-N L F

79 Phosphate 35 Cyanide 32 Copper DDC

9 Bromine LR 41 Fluoride 64 Nitrate-N LR

76 pH TB 53 Iron Phen 67 Nitrite-N LR

15 Chlorine 55 Manganese L 74 pH CPR

86 Silica HI 64 Nitrate N LR 78 Phosphate L

45 Hydrazine 26 COD Low 85 Silica Lo

32 Copper DDC 77 Phenols END OF LIST

51 Iron Bipyr 78 Phosphate L

END OF LIST 90 Sulﬁ de LR

END OF LIST

NOTE: Sequences always end with END OF LIST to indicate that there are no

more tests in the sequence.

These alterable sequences allow a series of tests to be setup that are run

frequently. The order of the individual tests in the sequence is determined by the

user. After running a test, press EXIT to escape back to the Sequence menu.

Move the down to the next test listed and press *ENTER. Continue this

pattern until the entire sequence has been completed.

ALL TESTS is a ﬁ xed sequence containing the LaMotte pre-programmed tests

and User Tests.

Modiﬁ cation of the alterable sequence is accomplished through the EDIT

function. This function is explained in detail in the section titled EDIT.

It should be noted that if a %T/ABS test is to be included in a sequence, the

%T/ABS test must ﬁ rst be setup as a User Test (but no actual calibration needs

to be performed, only select a name and wavelength).

Pressing the EXIT button while in a sequence menu will escape back to the

PROGRAMMED TESTS menu.

Pressing the OFF button at any time will turn the SMART Spectro off.