Use and Care Manual

Use and Care Manual

Ultra Durex™ DE-3320, 3322, 3325

Int/Ext Acrylic Waterborne DTM High Gloss Enamel

Surface Preparation

All surfaces must be dry, clean, sound and free of contaminants. Remove all dirt,

grease, chalk, mildew, oil, rust, concrete curing agents, chalk, dust, and other soluble

contaminants from steel surfaces by washing with solvent, vapor, cleaning

compound or other method.

Remove all loose mill scale, loose rust, loose paint, and other loose detrimental

foreign matter by hand chipping, scraping, sanding, and wire brushing or by power

wire brushing, power sanding, power grinding, power tool chipping, and power tool

descaling.

Prime if required as per recommended specifications of this product for surfaces

like: concrete, plasters, gypsum wallboard, drywall, wood, plywood, steel,

aluminum, galvanized steel, other composition materials or vinyl siding with the

recommended Lanco® primer or primer/sealer, following application instructions.

Glossy surfaces should be lightly sanded and primed previous to new paint

application.

Recommended Paint Systems

Iron and Steel:

Surface preparation: SSPC-SP2 / SP3

Primer, apply 1 coat : Oil-Red Oxide Primer

Paint, apply 2 coats: Ultra Durex™

Galvanized Metal and Aluminum:

Surface preparation: SSPC-SP1

Primer, apply 1 coat : Oil-White Galvanized

Paint, apply 2 coats: Ultra Durex™

Masonry and Concrete:

Surface preparation: SSPC-SP13

Primer, apply 1 coat : Stain Killer™ Primer

Paint, apply 2 coats: Ultra Durex™

Wood:

Surface preparation: Dry and Clean

Primer, apply 1 coat : Stain Killer™ Primer

Paint, apply 2 coats: Ultra Durex™

PAGE 1
Use and Care Manual Ultra Durex™ DE-3320, 3322, 3325 Int/Ext Acrylic Waterborne DTM High Gloss Enamel Surface Preparation All surfaces must be dry, clean, sound and free of contaminants. Remove all dirt, grease, chalk, mildew, oil, rust, concrete curing agents, chalk, dust, and other soluble contaminants from steel surfaces by washing with solvent, vapor, cleaning compound or other method.
PAGE 2
Use and Care Manual Surface Preparation Standards SSPC-SP1 Solvent Cleaning Removal of all visible oil, grease, soil, drawing and cutting compounds, and other soluble contaminants from steel surfaces with solvent LANCO® Lacquer Thinner LT-102, vapor cleaning, alkali, emulsifying agent, or steam. SSPC-SP2 Hand Tool Cleaning Removes all loose mill scale, loose rust, loose paint, and other loose foreign matter by hand chipping, scraping, sanding, and wire brushing.
PAGE 3
Use and Care Manual New Aluminum: New surfaces must be free of oils and lubricants often used in the fabrication or machining of aluminum. Use solvent cleaning preparation SSPC-SP1 with LANCO® Lacquer Thinner LT-102 to clean and remove any foreign matter that could affect the performance of the coating. This can also be accomplished on exterior products by weathering for a month to six weeks prior to the application of primer. Surface must be clean and free of contaminants.