SDS

RC-994 - URETHANIZER
Safety data sheet
according to 29 CFR 1910.1200
SECTION 7: HANDLING AND STORAGE (continued)
A.-
Technical measures for storage
B.-
General conditions for storage
Avoid sources of heat, radiation, static electricity and contact with food. For additional information see subsection 10.5
7.3
Specific end use(s):
Except for the instructions already specified it is not necessary to provide any special recommendation regarding the uses of this
product.
Minimum Temp.:
45 ºF
Maximum Temp.:
100 ºF
Maximum time:
24 Months
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
8.1
Control parameters:
Substances whose occupational exposure limits have to be monitored in the workplace
Identification
Occupational exposure limits
Limestone
8-hour TWA PEL
5 mg/m³
CAS: 1317-65-3
Ceiling Values - TWA
PEL
Titanium dioxide (aerodynamic diameter ≤ 10 μm)
8-hour TWA PEL
15 mg/m³
CAS: 13463-67-7
Ceiling Values - TWA
PEL
zinc oxide
8-hour TWA PEL
5 mg/m³
CAS: 1314-13-2
Ceiling Values - TWA
PEL
8.2
Appropriate engineering controls:
A.-
Individual protection measures, such as personal protective equipment
As a preventative measure it is recommended to use basic Personal Protection Equipment. For more information on Personal
Protection Equipment (storage, use, cleaning, maintenance, class of protection,…) consult the information leaflet provided by
the manufacturer. For more information see subsection 7.1. All information contained herein is a recommendation, the
information on clothing performance must be combined with professional judgment, and a clear understanding of the clothing
application, to provide the best protection to the worker. All chemical protective clothing use must be based on a hazard
assessment to determine the risks for exposure to chemicals and other hazards. Conduct hazard assessments in accordance
with 29 CFR 1910.132.
B.-
Respiratory protection
Pictogram
PPE
Remarks
Mandatory
respiratory tract
protection
Filter mask for gases and vapours
Replace when there is a taste or smell of the contaminant inside the face mask. If
the contaminant comes with warnings it is recommended to use isolation
equipment. Use respirator in accordance with manufacturer´s use limitations and
OSHA standard 1910.134 (29CFR)
C.-
Specific protection for the hands
Pictogram
PPE
Remarks
Mandatory hand
protection
NON-disposable chemical protective gloves
The Breakthrough Time indicated by the manufacturer must exceed the period
during which the product is being used. Do not use protective creams after the
product has come into contact with skin. Use gloves in accordance with
manufacturer´s use limitations and OSHA standard 1910.138 (29CFR)
As the product is a mixture of several substances, the resistance of the glove material can not be calculated in advance with
total reliability and has therefore to be checked prior to the application
D.-
Ocular and facial protection
Pictogram
PPE
Remarks
Mandatory face
protection
Face shield
Clean daily and disinfect periodically according to the manufacturer´s instructions.
Use if there is a risk of splashing. Use this PPE in accordance with manufacturer´s
use limitations and OSHA standard 1910.133 (29CFR)
Page 4/10
Date of compilation: 1/22/2019 Revised: 7/20/2020 Version: 6 (Replaced 5)
- CONTINUED ON NEXT PAGE -