Operation Manual

LANCOM 800+ – LANCOM DSL/I- 10+ – LANCOM DSL/I- 1611 Office

 Chapter 2: Installation

LEDs for LANCOM 800+ and LANCOM DSL/I-10+

Model example:

LANCOM DSL/I-10+

Power



This LED indicates that the device is operational. After the device has been

switched on, it will flash green for the duration of the self-test. After the self-

test, either an error is output by a flashing red light code or the device starts

and the LED remains lit green.

The power LED flashes red/green in alternation until a configuration

password has been specified. Without a configuration password, the

configuration data of the LANCOM is insecure. Under normal circum-

stances, you would assign a configuration password during the basic

configuration (see instructions in the following chapter). For informa-

tion about a later assignment of the configuration password see the

section ’Security settings’ →page 66.

Online 

The Online LED indicates the overall status of all WAN ports:



 





 

off Device off

green blinking Self-test when powering up

green constantly on Device ready for use

red/

green

blinking alternately Device insecure: configuration password not assigned

red blinking Time or connect-charge reached

off No active connection

green flashing Establishing first connection

green inverse flashing Establishing further connection

green constantly on At least one connection established

red constantly on Error establishing the previous connection