Operation Manual
Table Of Contents
- Preface
- Content
- 1 Introduction
- 2 Installation
- 3 Basic configuration
- 4 Security settings
- 5 Advanced wireless LAN configuration
- 6 Setting up Internet access
- 7 Options and accessories
- 8 Troubleshooting
- 9 Appendix
- Index
LANCOM IAP-54 Wireless - LANCOM XAP-40-2 - LANCOM XAC-40-1
Chapter 2: Installation
21
EN
Top hat rail mounting
Mount your device in in the required position on the top hat rail .
Wall mounting
Place the supplied top hat rail using the screws in the required position on
the wall.
Mount your device on the top hat rail as described above.
Connecting
Installation of the access point devices involves the following steps:
Antennas —screw the two supplied diversity antennas onto the front
side of the device:
Use the individual main connectors to build up separate Wireless
networks (e.g. for point-to-point applications).
Apply the main and the aux connector of a single WLAN module to
use the diversity function. The diversity function increases the quality
When mounting the device, please observe the information on lightning protection in
the LANCOM Outdoor Wireless Guide (download from www.lancom.eu
). Mounting wit-
hout adequate lightning protection could lead to serious damage to the access point
and the network infrastructure connected to it.