User Guide

1
© Copyright 2005 Printed
Before You Start
Your Land Pride Retro Fit Gearbox Mount is exclusively
designed for Land Pride 4400NT & 4400ST Trekers.
Please read these installation instructions and the
vehicle Operator’s Manual thoroughly before beginning.
Especially read information relating to safety concerns.
Also included in the Operator’s Manual is important
information on operation, adjustment, troubleshooting,
and maintenance for this attachment (some manual
sections do not apply to all accessories).
A separate Parts Manual for replacement parts can be
purchased from your dealer or downloaded free of
charge from our web site at www.landpride.com. Have
model and serial numbers handy when placing an order.
Manual Part Numbers:
• Operator’s Manual . . . . . . . . . . . . . . . . 700-108M
• Parts Manual . . . . . . . . . . . . . . . . . . . . 700-108P
General Information
These assembly instructions apply to the following Retro
Fit Gearbox Mounting Kits listed below:
700-373A NT Retro Fit Gearbox Mount
700-374A ST Retro Fit Gearbox Mount
Tools required:
•
Safety Glasses
• Work Gloves
• Center Punch
• Hammer
• Drill with 1/8" & 11/32" Drill Bits
• Torque wrench with required sockets listed below
• 7/16" Socket and box end or open end wrench
• 1/2" Socket and box end or open end wrench
• 9/16" Socket and box end or open end wrench
• M22 Socket and box end or open end wrench
• 3/16" Hex socket wrench
When you see this symbol, the subsequent
instructions and warnings are serious - follow
without exception. Your life and the lives of
others depend on it!
!
IMPORTANT: Before you begin, read these
instructions and check to be sure all parts and tools
are accounted for. Please retain these installation
instructions for future reference and parts ordering
information.
Assembly Instructions
A detailed listing of parts for each accessory kit is
provided on page 5. Use the list that is for your Treker as
a checklist to inventory parts received. Please contact
your local Land Pride dealer for any missing hardware.
Initial Preparations
1. Park vehicle on a flat surface, move gear shift lever to
forward, set park brake, lock the cargo box in the up
position, turn off engine and remove ignition key.
2. Chock front and back of front tires to prevent the
vehicle from rolling.
3. See Operator’s Manual 700-108M for proper jacking
procedures. Follow all safety precautions in the
manual. Jack the back of the vehicle up to remove
pressure on the back right shock.
Refer to Figure 1:
4. Remove M14 hex nut and hex head cap screw (#1).
Description
Figure 1
Refer to Figure 2:
5. Rotate shock back to access gearbox components.
Description
Figure 2
1
23676
23677
Treker 4400NT & 4400ST Series
Retro Fit Gearbox Mount
Assembly Instructions
6/14/05
Manual No. 700-372M