User's Manual

1
© Copyright 2008 Printed
Before You Start
Your High Rate Coil Springs are exclusively designed for
your Land Pride Treker. Please read these installation
instructions and your Treker Operator’s Manual
thoroughly before beginning. Especially read information
relating to safety concerns.
A separate Parts Manual for replacement parts can be
purchased from your dealer or available free of charge at
www.landpride.com. Have model and serial numbers
handy when placing an order.
Manual Part Numbers:
4200NT/ST & 4400NT/ST Trekers
• Operator’s Manual . . . . . . . . . . . . . . . . 700-108M
• Parts Manual . . . . . . . . . . . . . . . . . . . . . .700-108P
4210ST & 4410ST Trekers
• Operator’s Manual . . . . . . . . . . . . . . . . 700-108M
• Parts Manual . . . . . . . . . . . . . . . . . . . . . .700-109P
4220ST & 4420ST Trekers
• Operator’s Manual . . . . . . . . . . . . . . . . 700-504M
• Parts Manual . . . . . . . . . . . . . . . . . . . . . 700-504P
General Information
These assembly instructions apply to the following High
Rate Spring Kit listed below:
701-193A SPRINGS, ST TREKER HIGH RATE
It includes 2 Coil Springs Part Number 840-330C and this
manual. Please contact your local Land Pride dealer if
any components are missing.
Tools required:
•
Safety glasses, Work gloves & Tape Measure
• Spring compressing equipment
• 9/16" & 14mm wrench
• Pliers or small vise grips
Assembly Instructions
Refer to your Operator’s Manual Maintenance Section
for instructions on Securing Vehicle for Maintenance,
Tire Maintenance and Jacking the Vehicle.
When you see this symbol, the subsequent
instructions and warnings are serious - follow
without exception. Your life and the lives of
others depend on it!
!
IMPORTANT: Before you begin, read these
instructions and check to be sure all parts and tools
are accounted for. Please retain these installation
instructions for future reference and parts ordering
information.
Initial Preparations
1. Park vehicle on a flat surface, move gear shift lever to
neutral or park, set park brake if available, turn off
engine and remove ignition key.
2. Chock front and back side of rear wheels.
3. Loosen wheel lug nuts one-quarter turn on the right
front wheel.
4. Refer to your Operator’s Manual for detailed
instructions on jacking your vehicle. Place jack under
the vehicle’s body frame close to where the right front
A-Arm attaches to the frame and then jack the front
wheel off the ground.
5. For safety, support the wheel off the ground by
placing a jack stand under the body frame and then
lowering the vehicle onto the jack stand.
6. Remove right front wheel from the vehicle.
Figure 1
Shock & Spring Assembly Removal
Refer to Figure 1:
1. Loosen 3/8" hex nut (#5) 3 full turns. The clamping
lugs may need to be spread apart to free the shock &
spring assembly.
2. Remove bottom of shock & spring assembly (#11)
from brake assembly (#1) & steering bracket (#2) by
pulling down on the brake assembly and A-arm (#9).
For All Treker Series
High Rate Spring Kit
Assembly Instructions
3/31/08
Manual No. 701-194M