User Manual
Table Of Contents
- 10-0097 - Manual Cover.pdf
- Concentrator Manual 98-1031-1
- Table of Contents
- Preface
- Pre-Installation
- Field Configuration
- Concentrator Installation
- RF Filter Enable/Disable and Battery Replacement Kit
- Performing System Upgrades
- Troubleshooting
- Product Specifications
- Compliance
- Bench Testing
- About Firmware
- About Programming and Diagnostic Cables
- Sample Survey Sheet
- Power Cable Installation
- Glossary
- Index
Chapter 3 - Field Configuration Landis+Gyr
16 98-1031 Rev AA Series IV Concentrator U and I Guide
Concentrator Configuration
Follow the steps for configuring the Concentrator:
1. Plug the concentrator programming cable into the left-most barrel connector on the concentrator.
Figure 3 - 1. Concentrator with programming cable
2. Plug the serial cable labeled “Console” into the COM 1 port on the PC
.
Figure 3 - 2. Serial cable plugged into COM 1