User Manual
Table Of Contents
- 10-0097 - Manual Cover.pdf
- Concentrator Manual 98-1031-1
- Table of Contents
- Preface
- Pre-Installation
- Field Configuration
- Concentrator Installation
- RF Filter Enable/Disable and Battery Replacement Kit
- Performing System Upgrades
- Troubleshooting
- Product Specifications
- Compliance
- Bench Testing
- About Firmware
- About Programming and Diagnostic Cables
- Sample Survey Sheet
- Power Cable Installation
- Glossary
- Index
Landis+Gyr Chapter 3 - Field Configuration
Series IV Concentrator U and I Guide 98-1031 Rev AA 17
3. Navigate to Start | Accessories | Communications | Hyperterminal to launch Hyperterminal
on your PC. You must launch Hyperterminal before powering the concentrator.
Figure 3 - 3. Launch Hyperterminal
4. Power up the concentrator by inserting the power cable into the right barrel plug.
Figure 3 - 4. Concentrator with programming cable