User Manual
Table Of Contents
- 10-0097 - Manual Cover.pdf
- Concentrator Manual 98-1031-1
- Table of Contents
- Preface
- Pre-Installation
- Field Configuration
- Concentrator Installation
- RF Filter Enable/Disable and Battery Replacement Kit
- Performing System Upgrades
- Troubleshooting
- Product Specifications
- Compliance
- Bench Testing
- About Firmware
- About Programming and Diagnostic Cables
- Sample Survey Sheet
- Power Cable Installation
- Glossary
- Index
Landis+Gyr Chapter 3 - Field Configuration
Series IV Concentrator U and I Guide 98-1031 Rev AA 21
19. Type q for quit.
Figure 3 - 10. Type q for quit
20. Type y for yes.
Figure 3 - 11. Rebooting the concentrator via Hyperterminal
21. After the concentrator resets, close Hyperterminal.
22. Unplug the cable marked “Console” from COM 1.
23. Plug the Lan Protocol cable into COM 1.
Do not disconnect the power cables before the programming cable, the unit
uses battery backup. This runs down the battery and can affect routing.