User Manual
Table Of Contents
- 10-0097 - Manual Cover.pdf
- Concentrator Manual 98-1031-1
- Table of Contents
- Preface
- Pre-Installation
- Field Configuration
- Concentrator Installation
- RF Filter Enable/Disable and Battery Replacement Kit
- Performing System Upgrades
- Troubleshooting
- Product Specifications
- Compliance
- Bench Testing
- About Firmware
- About Programming and Diagnostic Cables
- Sample Survey Sheet
- Power Cable Installation
- Glossary
- Index
Landis+Gyr Chapter 4 - Concentrator Installation
Series IV Concentrator U and I Guide 98-1031 Rev AA 35
6. Attach the AC power cable to the concentrator. Use any of the approved power cable options.
Metal Pole vertical Mount Installation
The utility or municipality determines the final guidelines of where to install the concentrator. Know
and follow the utility or municipality guidelines before installing the concentrator and antennas.
Concentrator Metal Pole Mounting Kit
In addition to your chosen concentrator assembly kit, you need a mounting kit
• Kit number 45-1050 includes 8” rods for poles 3.5” to 5”.
• Kit number 45-1055 includes 12” rods for poles 5” to 7.5”.
These kits are identical except for the rod length, so only kit number 45-1050 is described below.
Table 4-6. 45-1050 Kit, Mounting, Light Pole, Concentrator
Image Part Number Name Quantity
101983-025
NUT, HEX, FLANGE 1/4-
20UNC, SS
8
16-0214
CONN, BULKHEAD, F/
F, TYPE N
1
19-2215
CBL ASSY,CYLINK
MALE-MAL E B,B
5.5 feet
3
22-0375
TIE WRAP, 28 INCH,
NYLON, WHITE
5