User Manual
Table Of Contents
- 10-0097 - Manual Cover.pdf
- Concentrator Manual 98-1031-1
- Table of Contents
- Preface
- Pre-Installation
- Field Configuration
- Concentrator Installation
- RF Filter Enable/Disable and Battery Replacement Kit
- Performing System Upgrades
- Troubleshooting
- Product Specifications
- Compliance
- Bench Testing
- About Firmware
- About Programming and Diagnostic Cables
- Sample Survey Sheet
- Power Cable Installation
- Glossary
- Index
5
Series IV Concentrator U and I Guide 98-1031 Rev AA 47
RF Filter Enable/Disable and
Battery Replacement Kit
The Series IV radio has an integrated RF Filter that can be enabled/disabled whenever necessary.
This chapter outlines the procedure to perform this task. It also outlines the battery replacement kit
and procedure.
Enable/Disable RF Filter
When the integrated RF filter is required for reducing interference, the filter can be enabled or
disabled in the field by qualified support personnel using RadioShop 4.1.
1. Verify that the Concentrator is highlighted on the Nodes Pane.
2. Right-click the Concentrator ID.
3. Select Enable RF Filter from the pop-up menu.
Figure 5 - 1. Enable (or Disable) the RF Filter
This procedure is only for the WAN radio (Series IV IWR) and not the BLT3 (LAN)
radio.