User Manual
Table Of Contents
- 10-0097 - Manual Cover.pdf
- Concentrator Manual 98-1031-1
- Table of Contents
- Preface
- Pre-Installation
- Field Configuration
- Concentrator Installation
- RF Filter Enable/Disable and Battery Replacement Kit
- Performing System Upgrades
- Troubleshooting
- Product Specifications
- Compliance
- Bench Testing
- About Firmware
- About Programming and Diagnostic Cables
- Sample Survey Sheet
- Power Cable Installation
- Glossary
- Index
Chapter 6 - Performing System Upgrades Landis+Gyr
64 98-1031 Rev AA Concentrator User and Installation Guide
E. Type q for Quit. Hyperterminal displays a message to let you know it is saving changes in
memory.
Figure 6 - 12. Hyperterminal quit Diagnostics
F. Type b to Boot the concentrator.
G. Type y for Yes to reset the system. Wait for the reset to complete. When Hyperterminal
restarts, it displays new IP address. Note the IP address; you will need it for subsequent
steps.
2. Copy the rom.bin and image.bin files to your c:\ drive before starting the update Flash memory
process.
3. Update the rom.bin file.
A. Open a command prompt window, usually under Start | Programs | Accessories. Keep
Hyperterminal open.
Try to position the c:\ prompt and Hyperterminal windows so that you can see
both of them at once.