User Manual
Table Of Contents
- 10-0097 - Manual Cover.pdf
- Concentrator Manual 98-1031-1
- Table of Contents
- Preface
- Pre-Installation
- Field Configuration
- Concentrator Installation
- RF Filter Enable/Disable and Battery Replacement Kit
- Performing System Upgrades
- Troubleshooting
- Product Specifications
- Compliance
- Bench Testing
- About Firmware
- About Programming and Diagnostic Cables
- Sample Survey Sheet
- Power Cable Installation
- Glossary
- Index
Chapter 6 - Performing System Upgrades Landis+Gyr
74 98-1031 Rev AA Concentrator User and Installation Guide
Testing the Concentrator
Test the concentrator to verify that it has been programmed correctly.
1. Unplug the ethernet cable from the router.
2. In the Diagnostics menu, type b to reboot the concentrator system.
Figure 6 - 31. Diagnostic Menu
3. Hyperterminal reboot
4. Type y to Yes, reset the system.Wait for the system to boot into normal operation.
Figure 6 - 32. Hyperterminal rebooting message
5. Type i to display firmware version information.
If the Diagnostics Menu does not display, then start over again from the first
step in this section.