User's Manual

OJQ `ÉääåÉí=t~íÉê=båÇéçáåí=fåëí~ää~íáçå=dìáÇÉ
fåëí~ääáåÖ=íÜÉ=`ÉääåÉí=t~íÉê=båÇéçáåí
3 Connect the three-conductor wire to the encoder register's terminals,
matching colors carefully: black to black, red to red, green to green.Thread
the cable around the strain relief posts of the encoder register.
Figure 2.3 Threading the cable around the strain relief posts
4 Apply moisture protection compound to terminal screws and exposed wires
(Dow Corning Compound #4 or Novagard® G661™)
Figure 2.4 Applying moisture compound
5 Snap the cover onto the encoder register.
6 Wipe away excess compound.
7 Route encoder cable from encoder to the mounted location of the CWE
Remote.
8 Mount the CWE Remote
9 Splice the wires from the CWE Remote to the three wires from the encoder
cable.
10 Match the colors carefully using the following table
Position the end of the cable jacket so that the compound will cover
it and it will not be visible when the cover is installed, as shown.
Be sure that the waterproofing compound completely seals the wires.
Apply compound under the cable and individual wires. Cover the top of the
cable, wires, and screws. Use enough compound so it flows from
openings when the cover is attached.
Table 1
Encoder Register 6060 Wire Color/Encoder Terminal
Neptune ProRead (ARB
VI)
Blk/Green Green/R Red/B