User's Manual

fåëí~ääáåÖ=íÜÉ=`ÉääåÉí=t~íÉê=båÇéçáåí
OJS `ÉääåÉí=t~íÉê=båÇéçáåí=fåëí~ää~íáçå=dìáÇÉ
Connecting a Badger, Neptune Auto or Sensus Encoder Register with Potted Leads
Use the following installation procedure for sites equipped with potted encoders.
1 Route the cable from the potted register to the CWE mounting location. Splice
in additional cable as necessary. When using additional cable, always match
colors: black to black, red to red, green to green. All color translations will be
done at the CWE Remote.
2 Prepare cable end for crimping:
a Using the cutting blade portion of the Wire Cutter and Stripper tool, cut
the wire connecting the encoder register to the touchpad (or other
device). The wire attached to the encoder register should contain at least
three wires. If not, replace the encoder register with a 3-wire version.
Figure 2.5 Wire cutter & stripper
b Using the #10 AWG position (second largest hole) on the 64-1919 wire
stripper, remove 1 inch of the external insulation from the cable coming
from the encoder register. Do not strip the insulation from the internal
wires.
Figure 2.6 64-1919 Wire Stripper
Do not open a potted encoder for any reason. This will void the manufacturer’s
warranty.