User Manual

Table Of Contents
Appendix A - GPR Waterproofing Landis+Gyr
116 98-1135 Rev AB Installation Guide
Figure A - 6. The Compound Must Cover Wires and Connectors for Watertight Seal
6. Arrange the GPR Pulse Input and Battery Interface cables as shown in Figure A - 7. The cables
must not interfere with or block the GPR antenna.
A CAUTION: The GPR Pulse Input cable must be inserted into the GPR enclosure strain relief
slot as shown. The shrink tubing on the cable must be inserted into the strain relief slot.
NOTE: Battery should not be connected until GPR is fully mounted.
7. Gently press the cable downward into the strain relief slot at midpoint of the heat shrink tubing
as shown in the following figures.
Figure A - 7. Arrange Cables As Shown Before Installing the GPR Cover
GPR Pulse
Interface
Cable
GPR Antenna