User Manual

Table Of Contents
2
Installation Guide 98-1135 Rev AB 25
Index Cover Pulser Install
and Operation Start Up
Introduction
The index cover pulser has a single channel. The channel is for measuring gas volume pulses. The
pulser is type Form-C. Before starting a module in for the first time, double check the following:
The index cover is properly installed to the meter index.
The GPR module is properly mounted to the meter.
NOTE: The output of the pulser is to be connected to Channel B on the GPR.
NOTE: It is the responsibility of the user to make sure the output pulse meets the minimum pulse
ON/OFF time of 50ms/50ms.
NOTE: If the battery is unplugged, do not connect the battery until the module is ready for operation
to start.
Figure 2 - 1. Sensor Channels