User Manual

Table Of Contents
Landis+Gyr Chapter 2 - Index Cover Pulser Install and Operation Start Up
Installation Guide 98-1135 Rev AB 27
NOTE: The cable connector is shown downside up.
Figure 2 - 3. Cable to GPR Connection for a Single Form-C Volume Input
The connector on the cable is mated to the channel B on the GPR Sensor Connector as shown in the
figure below.
NOTE: Battery should not be connected until GPR is fully mounted.
Table 2 - 1. Single Form-C Volume Wiring Definitions
GPR Sensor Index Cover
GPR Sensor
Connector Pin #
Signal and Description Lead Color Terminal
Description
and notes
1 N/C N/A N/A Not Applicable
2 N/C N/A N/A Not Applicable
3 N/C N/A N/A Not Applicable
4 N/C N/A N/A Not Applicable
5 Ground Drain N/A Not Applicable
6
CHAN B NO, Channel B
normally open
Orange NO Normally Open
7
CHAN B COM, Channel
B common
WHITE/ORANGE COM Common
8 CHAN B NC Green NC Normally Closed
9
CHAN B TAMPER TEST,
channel B tamper test
WHITE/GREEN NO Tamper Test
10 N/C N/A N/A Not Applicable
11 N/C N/A N/A Not Applicable