User Manual

Table Of Contents
Chapter 3 - American GPR Index Cover & GPR Install Landis+Gyr
32 98-1135 Rev AB Installation Guide
Figure 3 - 3. Remove Index Cover and Module Bracket Tamper Seals
C. Remove the index cover fasteners. If needed, use a 5/16 inch combination wrench to loosen
the index cover front bolt.
Figure 3 - 4. Remove Index Cover Fasteners
D. Remove the module bracket fasteners and carefully disconnect the module and index cover
assembly from the meter.
E. If the original gasket is damaged or cannot be reused, replace the index cover gasket. A
scraper and wire brush may be required to remove leftover gasket material.
3. Meter base plates without built-in tamper seal cups/towers, must use tamper seals and cups as
shown in Figure 3 - 5.
Remove Tamper Seals