User Manual

Table Of Contents
Landis+Gyr Chapter 3 - American GPR Index Cover & GPR Install
Installation Guide 98-1135 Rev AB 39
physically contact the index face or other pointers on the index. If contact occurs, the index
should be replaced with an approved index.
7. Remove the shim and verify that the wheel rotates freely while remaining level with the index
surface.
Figure 3 - 18. Balanced Dial Wheel Installed
Installing Index Into Index Cover
1. Gently press the cable toward the front of the cover to provide clearance for installation of the
index and to prevent stress or damage to the wires.
Figure 3 - 19. Gently Move Cable To Provide Clearance For Index
2. Hold the index at an angle to initially clear the wires and gently slide it into the cover while
holding the wires out of the way as shown.