User Manual

Table Of Contents
Chapter 4 - Rockwell GPR Index Cover & GPR Install Landis+Gyr
50 98-1135 Rev AB Installation Guide
Installing Back Mount Dial Wheels
Figure 4 - 7. Alignment Slots Top of Each Wheel Half
1. Insert one screw into the notched dial wheel half.
2. If the dial wheel halves have alignment slots, position them so that the slots on each half are
aligned. Turn the screw until it begins to thread into the threaded bottom wheel half as shown in
the following figures.
Figure 4 - 8. Notched Wheel Half with Screw Inserted
NOTE: For wheels WITHOUT alignment slots, there is no top or bottom, and there is no special
consideration regarding dial wheel assembly.
3. Slide threaded wheel half behind the rear vertical index drive shaft.
Figure 4 - 9. Place the Screw-bearing Notched Wheel Around the Index Drive Shaft
4. Rotate the notched wheel half in front of the shaft and insert the second screw.
5. Use a small Phillips-type screwdriver and turn each screw a few turns until they begin to thread
into the threaded wheel half.
6. Insert the 0.030 inch thick spacer shim between the dial wheel and the index top shaft support as
shown in the next figure.