User Manual

Table Of Contents
5
Installation Guide 98-1135 Rev AB 57
Schlumberger GPR Index
Cover & GPR Install
Schlumberger Index Cover & Gas Module Removal
U WARNING: The Schlumberger/Actaris 675-1000 meter is designed so that the index may face
the front or rear of the meter. Landis+Gyr only supports GPR cover use when installed:
with the index facing the front of the meter
where the meter inlet pipe is located at the left side of the meter.
Meter Preparation
1. Remove the tamper seals, screws, and index cover assembly from the meter.
2. If the meter has a Landis+Gyr Commercial Gas Module, perform the following steps.
A. Remove the index cover tamper seals.
B. Remove the module bracket tamper seals.
C. Remove the module bracket fasteners and index cover screws.
D. Carefully disconnect the module and index cover assembly from the meter.
Figure 5 - 1. Front and Rear Views: Index Cover with Commercial Gas Module and Bracket
3. Two types of Schlumberger/Actaris 675 index mounting brackets may be encountered during
GPR Index Cover installations.
Tamper Seal
and Screw
Tamper Seal
and Screws