User Manual

Table Of Contents
Landis+Gyr Chapter 5 - Schlumberger GPR Index Cover & GPR Install
Installation Guide 98-1135 Rev AB 63
6. Press wheel lightly but evenly against the shaft snap ring located at the rear of the shaft. The dial
wheel must not touch the gears on the shaft.
7. Tighten each screw a few turns at a time so that the two wheel halves remain parallel with each
other, and the dial wheel hole is centered on the shaft. Tighten the screws to 3.5 inch-pounds
± 0.50 inch-pounds.
U WARNING: Avoid damaging the dial wheel. Take care not to overtighten the set screws.
Figure 5 - 14. Dial Wheel on Shaft
Figure 5 - 15. Top View of Installed Dial Wheel
8. Install the index mounting bracket assembly onto the meter using the original screws. Tighten
the screws to 6 - 12 in-lb.
NOTE: The Schlumberger/Actaris 1000 meter is designed so that the index may face the front or
rear of the meter. Landis+Gyr only supports use of the GPR cover when installed with the index
facing the front of the meter where the meter inlet pipe is located at the left side of the meter.