User Manual

Table Of Contents
Landis+Gyr Chapter 6 - Sprague GPR Index Cover & GPR Install
Installation Guide 98-1135 Rev AB 73
Figure 6 - 9. Insert Shim and Alternately Tighten Screws To 1.2 inch-lbs. (±0.10 inch-lbs.)
U WARNING: To avoid damaging the index pointer and dial wheels, take care not to over-
tighten the set screws.
Figure 6 - 10. Front Mount Dial Wheel Installed
7. Verify that the dial wheel rotates freely without rubbing the index surface. Rotate the wheel
several times as shown in the next figure to verify that the wheel does NOT contact adjacent
index pointers.
Figure 6 - 11. Dial Wheel Must Not Contact Adjacent Pointers As It Rotates
A CAUTION: The installed dial wheel shall not move from the installed position, and cannot
physically contact the index face or other pointers on the index.
If contact occurs, Landis+Gyr recommends replacing the metal pointer index with an index
using plastic pointers so that the Balanced Dial Wheel can be used.
If dial wheel contact with the adjacent proving pointer tip is unavoidable, 1/4 of the adjacent
proving pointer tip may be removed with diagonal cutters, but only with permission from the
utility customer.