User Manual

Table Of Contents
Landis+Gyr Chapter 6 - Sprague GPR Index Cover & GPR Install
Installation Guide 98-1135 Rev AB 79
Figure 6 - 23. Tamper Cups and Screws
9. Verify that the magnet wheel does not contact the switch. A visible gap must exist between the
wheel and switch as shown in the following photograph.
Figure 6 - 24. Gap Must Be Visible Between Wheel and Switch
10. Install tamper seals into the tamper cups as shown in Figure 6 - 25.
Figure 6 - 25. GPR Assembly installed on a Sprague Large Diaphragm Meter
U WARNING: Take care not to pinch the index cover switch cable assembly in any way,
especially during the following installation steps:
During index cover and cable assembly installation onto the meter.