User Manual

Table Of Contents
Landis+Gyr Chapter 7 - Electronic Pulser Installation
Installation Guide 98-1135 Rev AB 87
NOTE: The four longer security Torx screws are GPR enclosure cover screws. Cover screws are
included in the 40-1672 GPR kit.
2. Secure the mounting bracket with GPR to the pipe.
A. Hold the GPR bracket assembly against the pipe so that the GPR is vertical and upright.
B. Use the four 1/4-20 x 2 inch screws included with the bracket kit to install the two U-shaped
clamps around the pipe to secure the GPR bracket to the pipe.
C. Tighten the screws to 10 in-lbs (+/- 2 in-lb).
Figure 7 - 4. GPR/Bracket Assembly for Horizontal Pipe Installation