Installation Guide Part 1

oÉëáÇÉåíá~ä=jÉíÉê=jçÇìäÉ=oÉíêçÑáí
`ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ RJNV
8UsetheremainingtwoscrewstoinstallthecoverontheMeterModule,
tighteningthescrewsuntilthecoversitssnug,thentightenanadditional
quarterturn.Insertthetworedtamperseals.
Figure 5.37 Sprague/Schlumberger/Actaris: Fasten Cover Screws and Insert Tamper seals
9UtilizetheRFBustertoverifymoduleistransmitting,holdtheRFBusterwith
magnetsidetothetopupperleftquadrantofthemoduleplasticandholdthe
buttonuntil10beepsarereceived.
10 Cleanupanydebrisfromtheretrofitandinstallationprocesses,andleavea
doorhangertagwi
than
yappropriateinformationfilledin,ifdoorhangers
arespecifiedduringinstallertrainingforthatutility.
11 Attheendoftheday,theinstallerreturnstotheCrossDockforthecheck‐in
process.Theinstallershouldalsoturnininventoryofunused,defective,or
brokengasMeterModules.Theins
tallermustcheckinal
lHandheldsissued
atthestartoftheshift.Theinstallerisresponsibleforreconcilingany
discrepanciesinchangeoutdatabeforethecheck‐inprocesscanbe
completed.MeterModuleswillnotbecheckedouttoaninstallerwhohasnot
completedthepreviousdayʹscheck‐inprocess.