Installation Guide Part 1

`çããÉêÅá~ä=~åÇ=fåÇìëíêá~ä=jÉíÉê=jçÇìäÉ=fåëí~ää~ íáçå
`ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ SJV
13 AttachthemountingbrackettothemeterusingthelargeFillisterscrews
provided.Useatampercupsealononeortwoofthescrews.Thetorque
requirementis30‐40inchpounds.Installthetwotamperseals.
Figure 6.15 American CG3:meter module with mounting bracket installed
14 Installtampercapsoverremainingfivescrews.
15 UtilizetheRFBustertoverifymoduleistransmitting,holdRFBusterwith
magnetsidetothetopupperleftquadrantofthemoduleplasticandholdthe
buttonuntil10beepsarereceived.SeeAppendix C
,UsingtheRFBusterfor
moreinformation.
16 Cleanupanydebrisfromtheretrofitandinstallationprocessesandtieany
loosecableswithtiewraps.
17 Proceedtothenextinstallationsite.
18 Attheendoftheday,returntotheCrossDockforthecheck‐inprocess.Turn
ininventoryofunused,def
ective,orbrokengasMeterModules.Checkinthe
handheldcomputer.Theinstallermustreconcileanydiscrepanciesinthe
changeoutdatabeforethecheck‐inprocesscanbecompleted.Thecrossdock
willnotcheckoutanyMeterModulestoaninstallerwhohasnotcompleted
thepreviousdayʹscheck‐inprocess.
Rockwell/Equimeter/Sensus Meter Module Installation
TherearetwotypesofRockwellmodules:CenterandOffset.Theleftside
illustratescenterprovingdialandtherightsideillustratesoffsetproving
dial.Verifytheappropriatetypebeforestartinginstallation.