Installation Guide Part 2

`ÉääåÉí=mìäëÉ=oÉÅçêÇÉê=jÉíÉê=jçÇìäÉ=fåëí~ää~íáçå
`ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ TJT
Table7.3WireColorMatching
4SeeAppendix A
:CrimpingWires,forinstructionsoncrimpingwires.
Programming CPR Endpoint for Operation with PRECO Switch
YoumustprogramtheCPRwiththeHandHeldcomputer(the“HandHeld”).
1 ConnecttheCPRProgrammingCabletotheCPRSerial/PowerConenctor
(yellowwire)below.
Figure 7.3 CPR Programming Cable Attached
2FollowtheHandHeldprompts toprogramtheendpoint.
3Whenprogrammingiscomplete,disconnecttheprogrammingcablefromthe
CPR.
EncoderRegister
PRECOWirecolor/CPRWireColor
PRECObluetogreenextensionto
CPRwhite
PRECOredtoredextensiontoCPR
red
PRECOwhitetoblackextensionto
CPRblack
blue
white
red
red
white
black
Connect only three wires using the color matching above.
ProgrammingCable
CPRSerial/Power
Connector