Installation Guide Part 2

`ÉääåÉí=mìäëÉ=oÉÅçêÇÉê=jÉíÉê=jçÇìäÉ=fåëí~ää~íáçå
`ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ TJV
2Pressandhold thebuttonontheRFBuster.PositiontheRFBusterlessthan
sixinchesawayfromtheleftsideoftheCPR.TheRFBustermakesaudible
beepsandtheLEDflashestoconfirmtransmissionoftheRFpacketsfromthe
endpoint.
3IftheRFBusterdetectspacketswithinonemi
n
ute,theinstallationisgood.If
theRFBusterdoesnotbeep,refertoʺTroubleshootingʺonpage 7‐9.
4 Attachthecoverusingthefourscrewsincludedinthehardwarekit.
5Cleantheareaandremovealldisposablematerials.
ENDPOINT REPLACEMENT
Pleasefollowtheinstructionsbelowtoreplaceanendpoint:
1OpenthefaceoftheCPR.
2Writedownthecolortranslation.
3Carefullycutanytiewraps.
4CutoffScotchloksnearthecrimp.
5 UnmounttheCPR.
6 Disconnectthebattery.
ProceedtoʺConnectingthePRECOSwitchtotheCPRʺonpage 7‐5.
TROUBLESHOOTING
RF Buster Does Not Beep When Testing
1First,verifythatthebatteryisproperlyconnected,redwiretoredwire.
2DoestheRFBusterbeepandlighttheLEDwhentheswitchisinitially
pressed?Ifnot,thebatteryintheRFBusterisdead.ReplacetheRFBuster
battery,oruseanotherRFBuster.
3Afteractivatingthemagneticswit chon
theCPR,holdtheRFBusterswitch
oncontinuously.PointtheLEDendoftheRFBustertowardthefrontofthe
CPR.HoldtheRFBusterbetween6”and12”fromthefrontoftheCPR.Wait
tenseconds.IftheRFBusterdoesnotbeep,replacetheCPRb
attery.
Customer Support
ToreachCustomerSupportatCellnet:
Email:[e-mail]
Telephone:1‐800‐791‐2567.
Hoursofoperation‐8:00a.m.ETto5:00p.m.ET
Do not use a cell phone or any other RF device while conducting
this test.