Installation Guide Part 2

d~ë=jÉíÉê=mêÉé~ê~íáçå=mêçÖê~ã=EdmêÉé F
VJNM `ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ
USING GPREP
ThissectiondetailsthestepstakenbytheendusertooperateGPreponadaily
basis.Thissetofproceduresassumesthefollowing:
•YourGPrepadministratorhasconfiguredthe.inifile.
•Youhavebasicknowledgeoftheprocessthatyouaretryingtoperformand
understandatwhichstepoftheprocessyouneedtouseGP
rep.
• Shooterboxor1‐wayprogrammingcable
Ifyouareusingtheprogrammingcable(usuallyinthefield):
1Installdriversandsetupthecableperinstructionsinthe1‐WayModule
ProgrammingCableGettingStartedGuide.
2Plugoneendofthecableintothemodule.
3Plugthe USBint
othelaptoporPC.
Figure 9.1 1-Way Programming Cable
Ifyouareusingtheshooterbox(usuallyintheofficeorshop):
1Plugthe b attery intotheshootercable.
2Powertheshooterbox.
3 ConnecttheshooterboxtoaCOMportonyourPC,andchoose thecorrect
COMportfromthedropdownmenuonGPrep(oritdefaultstothatport).
4Pl
ugtheshootercableintotheshooterboxandthemodule.
Figure 9.2 Shooter box
USB Connector
Module Connector