Installation Guide Part 2

d~ë=jÉíÉê=mêÉé~ê~íáçå=mêçÖê~ã=EdmêÉéF
`ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ VJON
•IfarecordalreadyexistintheprogramlogforascannedmodulePowerLAN
Address,GPrepdisplaysthefollowingmessage:
Figure 9.17 Duplicate Power LAN Address
•Ifyouselect“yes”,indicatingthatyouenteredthewrongmoduleID,thenre‐
enterthemeterIDfieldandPowerLANAddresstocorrectpossiblemis‐
enteredvalues.
•Ifyouselect“No”,indicatingthemoduleIDhasbeenenteredcorrectly,
GPrepdisplaysablinkingmessage“routetoMRB”.
Theresultofthisoperationisnotcaptur
edintheGPrepprogramlogfile.
RE-PROGRAM OLD
TheinstructionsandproceduresforRe‐Progra mOldarethesameasthosefor
ProgramNew,withtheadditionalfield“Dial”.Populateitwiththeindexreading
(dialreading).ThismodeismainlyutilizedduringtheO&Mphasetoprogram
meterswithnon‐zeroindices.
1SelectRe‐ProgramOldfromthemodedropdownwindowinthemain
menu.Th
ef
ollowingscreendisplays.
Figure 9.18 “Re-Program Old” Screen
Therearetwodistinctsectionsinthisscreenasw ell.Thetopsectioncontainsthe
followingfieldswhichcanbemodifiedbytheuser: