Installation Guide Part 2

d~ë=jÉíÉê=mêÉé~ê~íáçå=mêçÖê~ã=EdmêÉéF
`ÉääåÉí=d~ë=jçÇìäÉ=~åÇ=jÉíÉê=fåëí~ää~íáçå=dìáÇÉ VJOR
3 Connectthe1‐WayProgrammingCableorshootercabletothemodule
programmingport.Thefollowingscreendisplays.
Figure 9.22 MRB Screen with Module Plugged In
4Scan(enter)theModuleIDinLANAddressfield.
GPrepcomparesthevalueenteredinthisfieldwiththeLANAddress
programmedinthemodule.
GPreprejectsanydiscrepanciesinvalues,andpromptsyoutore‐entertheLAN
Addressorrejectthemodule.
5Entertheind exdialvaluesbyreadingthedialsandenteringtheval
uesread
fromrighttoleft.
If the Meter Type selected on the menu bar does not match the module type under test,
GPrep displays a dialog box indicating “wrong module Type” and a blinking “Module
reject” message. GPrep does not allow the operator to resume programming function.
If the current parameters do not match the predetermined value, a warning
message,”reject parameters” displays.
The value entered in the dial field are be compared with the module’s programmed read.
GPrep displays the following screen if there is any discrepancy and provides the option to
change the dial read if the operator has entered the wrong value