Installation Guide Part 2
APPENDIX
G
FCC
AND
IC
COMPLIANCE
FCC
CLASS
B
This device complies with Part
15
of
the FCC rules. Operation
is
subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part J5
of
the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in
a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used
in
accordance with the Instructions, may
cause harmful interference to radio communications. However, there
is
no
guarantee that interference will not
occur
in
a particular installation.
If
this
equipment does cause harmful interference to radio
or
television reception, which
can be determined
by
turning the equipment
off
and on, the user
is
encouraged to
try to correct the interference
by
one
or
more
of
the following measures:
• Reorient
or
relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult Cellnet
or
an experienced radio technician for help.
Changes
or
modifications
to
this
device
not
expressly
approved
by
Cellnet
Technol-
ogy,
Jnc.
could
void
the
user's
authority
to
operate
the
equipment.
FCC
10
and
Industry
Canada
10
Compliance
Labeling
Residential Gas 3
meter
modules include the following internal
and
external label-
ing
to
comply
to
FCC
and Industry
Canada
requirements:
• Cellnet Model:
printed
on
the
Printed Circuit
Board
internal
to
the
unit
•
FCC
ID: R7PEGOR3S2 (visible
on
the
label
on
the front
of
the
unit
and
printed
on
the
Printed Circuit
Board
internal to the unit)
•
IC
ID: 5294A-EGOR3S2 (visible
on
the
label
on
the
front
of
the
unit
and
printed
on
the
Printed Circuit
Board
internal
to
the unit)
8-1
FCC and
IC
Compliance