Data Sheet

Data Sheet 98-2539 Rev AA | 7
LTE-M Cellular Communication Module Data Sheet
 WARNING: Changes or modifications to this device not expressly approved by Landis+Gyr
could void the user’s authority to operate the equipment.
RF Exposure
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of
20cm between the radiator and your body. This transmitter must not be co-located or
operated in conjunction with any other antenna or transmitter.
Cet équipement est conforme aux limites FCC d'exposition aux radiations définies pour un
environnement non contrôlé. Cet équipement doit être installé et utilisé à une distance
minimale de 20 cm entre le radiateur et votre corps. Cet émetteur ne doit pas être co-
implantés ou exploités en conjonction avec une autre antenne ou émetteur.
Requirement for Modular Certification
The LTE-M Cellular module is approved for use with the inverted-F PCB trace antenna
integrated on the board for the ZigBee radio.
The LTE-M Cellular module is not available as a standalone product, it is only approved for
use in Landis+Gyr products and is not intended for sale to third-party integrators.
Additional Testing, Part 15 Subpart B Disclaimer
The end product with the LTE-M Cellular module may also need to pass the FCC Part 15
unintentional emission testing requirements and be properly authorized per FCC Part 15
Subpart B.
Industry Canada
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (EIRP) is not more
than that necessary for successful communication.
This radio transmitter (5294A-EG1R1S7) has been approved by Industry Canada to
operate with the antenna types listed below with the maximum permissible gain and
required antenna impedance for each antenna type indicated. Antenna types not included
in this list or having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
Approved Antennas: Inverted-F PCB Trace, 2.4 - 2.475 GHz, Max Gain -3.07 dBi.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour
l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage