Certification Exhibit FCC ID: R7PFTAR1S1 IC: 5294A-FTAR1S1 FCC Rule Part: 15.247 IC Radio Standards Specification: RSS-210 ACS Project Number: 14-0447 Manufacturer: Landis+Gyr Technology, Inc. Model: Field Tool Adapter 5015 B.U.
Draft 1/19/2015 NAM Field Tool Adapter (Comms Adapter) Quick Start Guide Publication: 98-1544 Rev AA LANDIS+GYR CONFIDENTIAL INFORMATION
Draft 1/19/2015 Limitation on Warranties and Liability Information in this document is subject to change without notice. This manual or any part of it thereof may not be reproduced in any form unless permitted by contract or by written permission of Landis+Gyr.
Draft 1/19/2015 Field Tool Adapter (Comms Adapter) Quick Start Guide Product Description The Field Tool Adapter (Comms Adapter) is a lightweight, compact device that is designed to ensure comfortable carrying and holding by the tool user. The adapter tool is capable of decoding one-way and two-way networks in a Gridstream environment. The device also incorporates a bluetooth module that provides communication to the tool device (tablet or laptop) and eliminates the need for serial cable connection.
Draft 1/19/2015 Field Tool Adapter (Comms Adapter) Quick Start Guide Landis+Gyr NOTE: The LAN ID is a unique identifier for each endpoint. It always displays in hex. Landis+Gyr provides the LAN address. You cannot change the LAN ID of a radio. NOTE: The device was designed to operate at close range in order to minimize interference from unwanted readings while troubleshooting in the field. The Field Tool Adapter (Comms Adapter) kit includes a battery charger. Figure 2.
Draft 1/19/2015 Landis+Gyr Field Tool Adapter (Comms Adapter) Quick Start Guide Getting Started To establish communication with the Field Tool Adapter (Comms Adapter), perform the following steps: 1. Press and hold the power button on the right-hand side to turn the adapter on. 2. Establish bluetooth communication with the tablet/laptop: A. From the Devices and Printers tab, locate or show the bluetooth devices. A list of bluetooth devices is displayed. B.
Draft 1/19/2015 Field Tool Adapter (Comms Adapter) Quick Start Guide Landis+Gyr FCC Compliance Information Compliance for Class B Devices This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Landis+Gyr Draft 1/19/2015 Field Tool Adapter (Comms Adapter) Quick Start Guide Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Draft 1/19/2015 Field Tool Adapter (Comms Adapter) Quick Start Guide 8 98-1544 Rev AA Landis+Gyr Quick Start Guide
