User Manual

ManualsBrandsLandis+Gyr Technology ManualsElectronicsCommunications Adapter

Table Of Contents

5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598

Certification Exhibit

FCC ID: R7PFTAR2S1

IC: 5294A-FTAR1S1

FCC Rule Part: 15.247, 15.249

IC Radio Standards Specification: RSS-210, RSS-247

ACS Project Number: 15-0159

Manufacturer: Landis+Gyr Technology, Inc.

Model: Communications Adapter

Summary of content (9 pages)

PAGE 1
Certification Exhibit FCC ID: R7PFTAR2S1 IC: 5294A-FTAR1S1 FCC Rule Part: 15.247, 15.249 IC Radio Standards Specification: RSS-210, RSS-247 ACS Project Number: 15-0159 Manufacturer: Landis+Gyr Technology, Inc. Model: Communications Adapter 5015 B.U.
PAGE 2
Communications Adapter Quick Start Guide Publication: 98-1544 Rev AB LANDIS+GYR CONFIDENTIAL INFORMATION
PAGE 3
Limitation on Warranties and Liability Information in this document is subject to change without notice. This manual or any part of it thereof may not be reproduced in any form unless permitted by contract or by written permission of Landis+Gyr.
PAGE 4
Communications Adapter Quick Start Guide Product Description The Communications Adapter is a lightweight, compact device that is designed to ensure comfortable carrying and holding by the tool user. The adapter tool is capable of decoding one-way and two-way networks in a Gridstream environment. The device also incorporates a bluetooth module that provides communication to the tool device (tablet or laptop) and eliminates the need for serial cable connection.
PAGE 5
Communications Adapter Quick Start Guide   4 Landis+Gyr NOTE: The LAN ID is a unique identifier for each endpoint. It always displays in hex. Landis+Gyr provides the LAN address. You cannot change the LAN ID of a radio. NOTE: The device was designed to operate at close range in order to minimize interference from unwanted readings while troubleshooting in the field.
PAGE 6
Landis+Gyr Communications Adapter Quick Start Guide The Communications Adapter kit includes a battery charger. Figure 2. Communications Adapter Kit Required Software For specific software and firmware questions, contact your Program/Project Manager directly or your Customer Account Representative.
PAGE 7
Communications Adapter Quick Start Guide Landis+Gyr Getting Started To establish communication with the Communications Adapter, perform the following steps: 1. Press and hold the power button on the right-hand side to turn the adapter on. 2. Establish bluetooth communication with the tablet/laptop: A. From the Devices and Printers tab, locate or show the bluetooth devices. A list of bluetooth devices is displayed. B.
PAGE 8
Landis+Gyr Communications Adapter Quick Start Guide FCC Compliance Information Compliance for Class B Devices This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 9
Communications Adapter Quick Start Guide Landis+Gyr Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.