Series 6 Network Node N651 Data Sheet Publication: 98-2109 Rev AA LANDIS+GYR CONFIDENTIAL INFORMATION
Limitation on Warranties and Liability Information in this document is subject to change without notice. This manual or any part of it thereof may not be reproduced in any form unless permitted by contract or by written permission of Landis+Gyr.
Series 6 Network Node N651 Data Sheet Introduction Landis+Gyr’s Series 6 Network Node (N651) is key to building a single, integrated IoT network for your utility future. This product is a fully functional, dual-band mPCIe Network Interface Card (NIC) for simple network and sensor-device integration. This technology is foundational to Landis+Gyr’s industry-leading utility IoT networking solution, Gridstream® Connect.
Series 6 Network Node N651 Data Sheet Landis+Gyr Table 1. Series 6 Network Node N651 Specification Element Description Radio Model Series 6 Network Node N651 Communication Protocol (PHY) IEEE 802.15.4g, IEEE 802.15.4e, IPv6 (RPL & 6LoWPAN) MAC/PHY Features MAC Simultaneous multi-band support Automatic selection of ‘best’ Band based on Link Quality Automatic selection of ‘best’ Modulation based on Link Quality PHY Adaptive Power Control (ie.
Table 1. Series 6 Network Node N651 Specification (Continued) Element Description Channel Width 400 KHz Number of Channels 7 SUN Modulation Support 2-FSK: 50 – 200 kbps OFDM Option 3: MCS3 – MCS6 Output Power 50 mW – 1 W Receiver Sensitivity (IEEE 802.15.4) F2B50 = -108 dBm F2B100 = -103 (TBC) dBm F2B150 = -100 (TBC) dBm F2B200 = -99 (TBC) dBm O3M3 = -107 dBm O3M3 = -105 dBm O3M5 = -102 dBm O3M6 = -97 dBm 2.
Series 6 Network Node N651 Outline The PCB outline is shown below. Figure 2. Board Outline 1 Figure 3.
FCC, Industry Canada Compliance FCC Class B This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Requirement for Modular Certification N651 network node is approved for use with the antenna listed in the table below. Antenna types not included in the list below or a having higher gain than the maximum indicated for that type, are prohibited for use with this device. Make Model Type Termination 902 - 928 MHz Max. Gain 2400 - 2485 MHz Max. Gain Antenna Impedance Panorama Antennas BS-IN2421 Dipole Type- N 4.
fonctionnement. Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.
