Series 5 Network Node N501 & N551 Data Sheet Publication: 98-2386 Rev AA © Landis+Gyr 2020 | Proprietary + Confidential
Limitation on Warranties and Liability Information in this document is subject to change without notice. This manual or any part of it thereof may not be reproduced in any form unless permitted by contract or by written permission of Landis+Gyr.
Series 5 Network Node N501 & N551 Data Sheet Introduction Landis+Gyr’s Series 5 Network Node (RF Mesh - N501 & RF Mesh IP - 551) is key to building a single, integrated IoT network. This product is a fully-functional, Network Interface Card (NIC) that is mPCIe standard-enabled for simple network and sensor device integration. This technology is foundational to Landis+Gyr’s industry-leading utility IoT networking solution, Gridstream® Connect.
Series 5 Network Node N501 & N551 Data Sheet Table 1. Series 5 Network Node N551 Specification Element Description Radio Model Series 5 Network Node N551 Communication Protocol (PHY) IEEE 802.15.4g, IEEE 802.15.4e, IPv6 (RPL & 6LoWPAN) MAC/PHY Features MAC Automatic selection of ‘best’ Modulation based on Link Quality PHY Adaptive Power Control (ie.
Series 5 Network Node N501 & N551 Data Sheet Table 1. Series 5 Network Node N551 Specification (Continued) Data Sheet Element Description Number of Channels 44 Multicast Modulation 2-FSK 50 kbps Unicast Modulation Support 2-FSK: 50 – 200 kbps Data Rate Coverage 50 kbps – 150 kbps – 200 kbps Transmitter Output Power 50 mW – 974 mW (peak) Receiver Sensitivity (IEEE 802.15.
Series 5 Network Node N501 & N551 Data Sheet Table 2. Series 5 Network Node N501 Specification Element Description Radio Model Series 5 Network Node N501 Communication Protocol (PHY) RF Mesh IP (Proprietary) MAC/PHY Features MAC Automatic selection of ‘best’ Modulation based on Link Quality PHY Precision Output Power Management Hardware Capabilities Clock Speed 120 MHz RAM Memory 640 Kb FLASH Memory 2 MB + 4 MB External RF Modulation 2-FSK, 2-GFSK RF Bands Sub-GHz RF Port Single 50Ω U.
Series 5 Network Node N501 & N551 Data Sheet Series 5 Network Node N551 Outline The PCB outline is shown below. Figure 2.
Series 5 Network Node N501 & N551 Data Sheet Figure 3. B oard Outline 2 FCC, Industry Canada Compliance FCC Class B This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation.
Series 5 Network Node N501 & N551 Data Sheet Cet équipement est conforme aux limites d'exposition aux radiations FCC définies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé à une distance minimale de 33 cm entre le radiateur et votre corps. Cet émetteur ne doit pas être situé à proximité ou fonctionner en conjonction avec toute autre antenne ou émetteur. Requirement for Modular Certification N551 network node is approved for use with the antenna listed below.
Series 5 Network Node N501 & N551 Data Sheet Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.
