Landis+Gyr Comms Host Board Data Sheet Publication: 98-2464 Rev AA LANDIS+GYR CONFIDENTIAL INFORMATION
Limitation on Warranties and Liability Information in this document is subject to change without notice. This manual or any part of it thereof may not be reproduced in any form unless permitted by contract or by written permission of Landis+Gyr.
Comms Host Board Data Sheet Comms Host Board Overview The Comms Host board incorporates a power supply, ZigBee circuitry, stamped metal PIFA, and mPCIe connector to allow for integration of EIC (optional) + communication module assembly. This hardware architecture with mPCIe interface offers flexibility while accommodating various communication devices using a single interface. Figure 1 - 1.
Table 1.
The PCB outline is shown below ZigBee Stamped Metal Antenna Outline FCC, Industry Canada Compliance FCC Class B This device complies with Part 15 of the FCC rules.
undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason- able protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the Instructions, may cause harmful interference to radio communications.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada.
Figure 1 - 2 .
