Draft 07.11.
Draft 07.11.2022 A Limitation on Warranties and Liability Information in this document is subject to change without notice. This manual or any part of it thereof may not be reproduced in any form unless permitted by contract or by written permission of Landis+Gyr.
Draft 07.11.2022 A Series 6 MCM0 Data Sheet Introduction Landis+Gyr's Series 6 MCM0 is key to building a single, integrated IoT network for your utility future. This product is a fully functional Network Interface Card (NIC) in a multi-chip module form-factor to enable low-cost network and sensor device integration. This technology is foundational to Landis+Gyr's industry-leading utility IoT networking solution, Gridstream® Connect.
Draft 07.11.2022 A Series 6 MCM0 Data Sheet Table - 1. Technical Specifications (Continued) Element Description RF Ports 1 Table - 2.Sub-GHz Band Characteristics: North America Network Operating Mode RF Mesh IP Series 5 Compatible RF Mesh IP Green Field Wi-SUN Frequency Range (Fc) 902.4 MHz - 927.6 MHz 904 MHz - 926.8 MHz 902.2 MHz – 927.
Draft 07.11.2022 A Series 6 MCM0 Data Sheet Series 6 MCM0 Outline The PCB outline is shown below: Figure 2. PCB Outline 1 Figure 3. PCB Outline 2 FCC and Industry Canada Compliance FCC Class B This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation.
Draft 07.11.2022 A Series 6 MCM0 Data Sheet and used in accordance with the Instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
Draft 07.11.2022 A Series 6 MCM0 Data Sheet Figure 5. PCB Stack Up Information on Test Modes and Additional Testing Requirements A diagnostic test mode is available to device integrators that allows control of the transmitter in order to execute FCC 15.247 compliance testing. This mode of operation provides a basic command interface over a dedicated serial port.
Series 6 MCM0 Data Sheet Draft 07.11.2022 A should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. This radio transmitter (identify the device by certification number, or model number if Category II) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated.
