Installation Manual

Mobile Station System (Rover) : Setting
Items Setting Value / Description
Receiver Mode Please set to Rover.
PORT1
Baudrate
Set PORT1 Cable (RS232C) communication
speed.
Please adapt the speed with the capture
device or App for the NMEA output port.
PORT2
Baudrate
（
Modem
）
Set PORT2 Cable (RS232C) communication
speed.
This setting is used when using RTK with
the radio.
Please match with the RS232C
communication speed of the radio.
NMEA TCP Port 50001
This is the port number for NMEA output to
SmartMate. Please do not change.
RTCM TCP Port 50002
This is the port number for outputting RTCM
messages (RTK correction data) to
SmartMate.
Please do not change.
Items Setting Value / Description
NMEA Out Rate This is the output cycle of the NMEA
message output to PORT1 or TCP port
(50001).
Please select from 1Hz, 5Hz, 10Hz.
GGA Use Select ON to output NMEA-GGA and OFF to
not output.
GNS Use Same as above
GSA Use Same as above
GSV Use Same as above
RMC Use Same as above
VTG Use Same as above
ZDA Use Same as above
Elevation Mask Elevation mask setting.
Please select from 5 degrees, 10 degrees,
15 degrees, and 20 degrees.
12