Installation Manual

Reference Station System (Base Station) : Setting
Items Setting Value / Description
Receiver Mode Please set to Base Station.
PORT1
Baudrate
（
Modem
）
Set PORT1 Cable (RS232C) communication
speed.
This setting is used when using RTK with
the radio.
Please match with the RS232C
communication speed of the radio.
RTCM Out TCP
Port
Please set the TCP port number to output
the RTCM message.
*Not normally used.
GPS Select ON when using GPS satellites and
OFF when not using them.
When using a radio, select GPS, GLONASS,
Beidou, or Galileo. If the total number of
satellites exceeds 30, the communication
speed of the radio may not be in time and
the positioning result may be affected.
(Assuming an air-intermediate speed of
4800 bps for the radio.
）
Ex
）
GPS + GLONASS, GPS + Beidou, etc.
GLONASS Same as above
Beidou Same as above
Galileo Same as above
Items Setting Value / Description
Base Lat Enter the coordinates (latitude) of the
location where the base station GNSS
antenna is installed in decimal (degree
format). Ex) 35.379506622
Base Lon Enter the coordinates (longitude) of the
location where the base station GNSS
antenna is installed in decimal (degree
format). Ex) 139.644391867
Base Alt Enter the height (ellipse height) of the
location where the base station GNSS
antenna is installed. Ex) 50.123
（
m)
NTRIP Caster
Host
Set when using SC_Rover as an NTRIP
server.
Please enter the Host address of NTRIP
Caster.
NTRIP Caster
Port
Please enter the connection port number to
NTRIP Caster.
NTRIP Caster
MountPoint
Please enter the mout point to NTRIP Caster.
NTRIP Caster
Password
Please enter NTRIP Caster password.
*NTRIP Caster support is scheduled to be released after October 2020.
Currently, entering the connection information does not work.
13